Skip to main content

iPhone Plus 7 case design - Panda



Completion date: August 2018

I drew this by hand. I learned the sketching from a sketchbook from Japan Tokyo Ueno Zoo Gardens 上野動物園. I sketched this completely by hand in pencil first (copying, without tracing!  I think it is amazing I did it), then bold the strokes with black coloring pencil.  The top tiles design was copied from a photo on Pinterest.  I used this until today, after I asked my son to draw me a new iPhone case design.

Comments

Post a Comment

Popular posts from this blog

DIY Keyboard drawer installation

Completion Date: May 24, 2020 Work from home has given me chance to use my DIY table (35cm*50cm) ever more than before.  I feel great, but I realize the fact that I don’t have enough space if I want to work on my iPad at the same time.  I bought this mini drawer tracks so I can create this space. Material:  - 10 inch (25cm) keyboard drawer tracks, 1 pair (Taobao, RMB12.5) - 24*36cm wooden board (left over I have at home) Steps: 1.  Stretch the keyboard tracks to full extent.  Fit the wooden board to the end of the track and mark the holes with pencil. 2. This is 2.5mm drill bit.  Drill pilot holes to the marked holes.  Do the same for the other side. 3. Take my table top out and flip upside down.  Fit the keyboard drawer and trace the outline and mark the holes with pencil.  Re-verify the keyboard outer edge aligns in parallel with the table top’s outer edge. 4. Drill the holes ...
Post a Comment
Read more

Star cushion

Completion date: Jun 12 2020 Steps 1. Trace the star shape onto the fabric.  Double over the fabric.  Apply pins to secure the edges.  Cut out. 2. Install a platform on the sewing machine.  3. Whenever I need to turn the fabric I place the needle down on the fabric before turning the fabric.  Sew until I get a 15 cm opening. 4. Flip the fabric inside out and put the foam filling inside the star cushion.  Bind off the opening by hand sewing. My daughter requested for a star cushion.  I recycled filling of a foam-type cushion into this one.  This was the first time I used a platform.  The table was not long enough but I put something underneath to support the platform.  She was pleased with it though it wasn’t pink as she originally requested.  Below in the picture was her little hand!
Post a Comment
Read more

Fixing of retractable badge holder

Completion date: October 2, 2021 My retractable badge holder’s string is thinning and would be broken soon.   I cut it short.  Pull the rotten part out with a tweezer. Insert the string from this end.  Tie a knot.   Reinstall the silver triangle back. 
Post a Comment
Read more